#Topaz denoise vs nik dfine how to#
#Topaz denoise vs nik dfine manual#

This may be too much noise reduction so you may need experiment around with this to get the best results (or use a layer mask/brush feature to paint in the noise reduction you do and donвЂ™t want). You should now see better (or at least more aggressive) noise reduction than you did the first time. Step 3 is when you click Measure Noise so that the noise reduction is now applied to the areas where you drew rectangles. HereвЂ™s examples of two places I did additional measurements on вЂ“ mouse in and out of the image to see the locations on the top and between the Lego characters legs:Дrag new rectangles over areas not handled very well

#Topaz denoise vs nik dfine manual#

What you are doing here is telling Dfine to include sample from those areas when doing the noise reduction which means that it will be more aggressive next time it removes noise (which is now a manual operation discussed later). Step 2 is to click the Add Rectangle tool and draw rectangles around the areas where the automatic noise reduction didnвЂ™t work very well. These are the measure points that Dfine detected automatically. YouвЂ™ll notice that there are rectangles in various places on the Lego guy, the glass and the stand disc. Step 1 is to change the method from Automatic to Manual as shown here: To begin with, when you use Dfine you probably do like most people out there and just run it and get this dialog:ДЄutomatic Profile Applied вЂ“ The Default BehaviorДЄutomatic method is very good and most of the time will give you the results you want with no further action required.However, if you are unhappy with the results, then try Manual Mode.

#Topaz denoise vs nik dfine how to#

Essentially IвЂ™ll demonstrate how to use manual mode in Dfine to get better results than youвЂ™ll get by default in Dfine and many other noise reduction products. To respond to him properly required a complex response complete with pictures, so I decided IвЂ™d just do a blog article for the response so others might be able to benefit from this as well. One of the members of the Photography club I belong to asked a questioned about Nik SoftwareвЂ™s Dfine versus Topaz Labs Denoise for which I felt the solution was using Nik SoftwareвЂ™s Dfine in manual mode (something I discuss in my Noise Reduction Series).